SHERLINE Rocker Tool Posts

P/N 3057

Use of the Rocker Tool Post

The cutting edge of a lathe tool should be set right on or just slightly below the center line of the part being machined. With new lathe tools this is not a problem, because the SHERLINE tool posts are made to hold them at the correct height. Older tools that have been sharpened numerous times may require shimming to bring them up to the correct height.

The SHERLINE Rocker Tool Post is designed to eliminate the need for shimming. The height of the cutting edge can be changed by simply adjusting the two clamping screws. This inexpensive accessory reduces setup time and also extends the life and the usefulness of your old lathe tools.

Return to Lathe Accessories Section

Copyright 1996, Sherline Products Inc. All rights reserved.
No part of this web site, including the text, photos or illustrations, may be reproduced or transmitted in any other form or by any means (electronic, photocopying, recording or otherwise) for commercial use without the prior written permission of Sherline Products Inc.